Screens lie.Paper doesn’t.
A riso press and a school of print production for designers who grew up on screens. Learn what happens between the file and the sheet: dots, angles, inks, traps and blades.
Your screen adds light. Paper takes it away.
A monitor starts black and adds red, green and blue light until it reaches white. A press starts white and lays down inks that each absorb some light, so every layer makes the sheet darker. That is why the vivid green on your screen goes muddy on paper: it sits outside what four inks can mix.
Light adds up to white
Every overlap is brighter. Pure #00FF00 is a light source, and no ink can glow.
Ink adds up to mud
Every overlap is darker. Three process inks make a brown black, so presses add a fourth plate: K.
Some inks have no recipe
A spot ink is mixed before it reaches the press. Clean orange is one of the first colours to fall outside CMYK, which is why six colour systems added an orange plate.
Presses can’t print grey. Only dots.
A press puts ink down or it doesn’t. There is no 40% ink. So how does it print a gradient?
The tone is converted into dots on a fixed grid. Big dots read as dark, small dots as light. Your eye does the averaging.
Teal prints on top. At the same angle every dot lands on its neighbour, and the tiniest slip shifts the colour.
Each plate gets its own angle. Process work uses C 15°, M 75°, Y 0° and K 45°: thirty degrees between the strong inks.
Under a loupe, the two grids lock into small flower shapes. That rosette is what a healthy print looks like up close.
Put teal at 70°, only 5° from orange, and the grids beat against each other. Those rippling bands are moiré.
Where inks meet, something has to give.
A teal panel and an orange disc. Each is its own drum, its own pass through the machine.
Orange prints straight on top of teal. Transparent inks multiply, so the overlap turns a deep green black. Great on purpose, a disaster by accident.
The teal plate gets a hole exactly where the disc sits. Now orange lands on bare paper and stays orange.
Paper moves. Here the orange drum is off by 2 mm, and a crescent of bare paper appears beside the disc.
Trapping fixes it. The lighter ink grows a little past its edge, so the plates overlap and the gap can never open.
Or the darker ink grows inward, shrinking the hole. Same overlap, but the shape keeps its outline. Riso traps run 0.3 mm or more.
Blades drift. Design for the drift.
- Bleed
Artwork that touches an edge runs 3 mm past it. It gets cut off, and that is the point.
- Trim
Where the blade is meant to fall. Meant to.
- Safe area
Keep text and logos 5 mm inside the trim, or the drift will nibble them.
- Crop and registration marks
Crop marks tell the cutter where. Registration targets tell the printer if the plates line up.
Ten things your printer wishes you knew.
The riso press
Build a two or three drum print from shapes and your own words. Pick inks, set dot size and angle per drum, slip the registration, choose paper and watch the dots swell.
Ink the drumsPreflight
Five files are about to go to press. Each has problems. Find them against the clock: missing bleed, RGB black, text on the trim, hairlines and rich black type.
Start the clock